Setup guide

Configuring Lustre to Connect to the
Autodesk Control Surface
After you have configured the IP address of the control surface, you must
configure Lustre to use the control surface.
To configure Lustre to use the Autodesk control surface on Windows- or
Linux-based workstations:
1 Turn the power on to each of the modules and look at the top display
panel on the module. It should display the panel name and ID.
2 After you install Lustre 2011, open the init.config file located in C:\Program
Files\Autodesk\<lustre version> in Windows, or in /usr/autodesk/<lustre
version> in Linux with a text editor.
3 In the ControlSurface section of the init.config file of your project,
enter the panel IDs for each panel.
ControlSurface
AutodeskPanels state=”On”
PanelIDs function=”0” grading=”0” navigation=”0”
Once the steps above are completed, the ACS panels will be recognized,
loaded, and connected when launching the application.
4 Start Lustre. The following message should appear in the Console:
Panel #<panel_ID> is detected
This confirms that the Autodesk Control Surface is enabled.
Connecting a Stand-Alone Tablet
If you do not have the modular Autodesk control surface panel that includes
the tablet, you can connect a stand-alone tablet.
To connect a stand-alone tablet, connect the tablet to USB Out 1 on the USB
extender.
NOTE On Windows-based workstations, you may need to restart Windows for
the tablet to be recognized. On Linux-based workstations, re-starting the Xserver
prompts tablet recognition. Press Ctrl+Alt+backspace to start the Xserver.
38 | Chapter 3 Connecting System Components