Setup guide

Connecting System
Components
Topics in this chapter:
■
Workflow for Connecting System Components in the Lustre Workgroup on page
31
■
Connecting the Autodesk Control Surface on page 32
■
Assigning an IP Address to the Autodesk Control Surface on page 35
■
Configuring Lustre to Connect to the Autodesk Control Surface on page 38
■
Connecting a Stand-Alone Tablet on page 38
■
Connecting the Slave Renderer to a Lustre Workstation on page 39
■
Connecting Video I/O to a Master or HD Station on page 40
■
Setting Up VTR Emulation on page 45
■
Connecting to a High-Speed Data Link Device (HSDL) on page 46
■
Connecting Audio Hardware on page 47
Workflow for Connecting System
Components in the Lustre Workgroup
After you have connected peripherals to your workstation, you are ready to
connect it to the Autodesk control surface, to video I/O hardware, and to a Slave
Renderer.
3
31