Setup guide

When the Infiniband topology (including driver) is fully installed, Autodesk
recommends adjusting specific configuration parameters in the Windows
operating system to optimize performance.
To install the Infiniband driver for use with a Windows-based Lustre
workstation:
1 Download the driver package to a temporary location on your system.
You can find the appropriate driver package here:
ftp://ftp.discreet.com/pub1/release/lustre/lustre2008/drivers/SilverStormHCA.msi
NOTE Contact Customer Support if you have any problems downloading
the driver package. See Contacting Customer Support on page 15.
2 Double-click the driver package and click Run.
The SilverStorm HCA Setup Wizard opens.
Click Next.
3 On the License Agreement page, read the agreement before selecting the
I Agree radio button. Click Next.
4 On the SilverStorm HCA Information page, read through the driver
manufacturer Release Notes, then click Next.
Infiniband Network Support for Lustre on Windows-based Workstations | 23