Setup guide

Connecting the Keyboard, Mouse, and
Monitor Calibration Device
Connect the mouse, keyboard, and monitor calibration device to the
workstation via the 4-port USB extender (TP.USB-EXT-400).
To connect the keyboard and mouse:
1 Connect the USB keyboard to port 2 on the remote unit of the USB
extender.
2 Connect the USB mouse to port 3 on the remote unit of the USB extender.
3 Connect the monitor calibration device (TP.MON-CAL-LCDCRT) to port
4 on the remote unit of the USB extender.
4 Use an RJ-45 cable to connect the remote unit of the USB extender to the
local unit of the USB extender.
5 Connect the local unit of the USB extender to USB1 port on the
workstation.
To enable the Eye-One calibration utility driver:
➤ Do one of the following:
■ For Windows-based workstations, if the driver is not already installed,
you will be prompted to install the monitor calibration device driver
when you restart the workstation. The driver is available from the
C:\Program Files\Autodesk\Lustre Color 2008 SP3\Calibration\drivers
directory.
■ For Linux workstations, once the software installation has been
completed, start the eyeone27 daemon on the workstation. Type:
/etc/init.d/eyeoned_2011 start
Connecting Storage
The storage connections for your system depend on whether you are running
Lustre on the Windows or Linux operating system.
Connecting the Keyboard, Mouse, and Monitor Calibration Device | 21