Setup guide

7 Select a language.
8 From the File menu, select Flash System ROM.
The Select a Drive menu appears.
9 Click Optical Drive.
The Select a Drive confirmation menu appears.
10 Press F10 to confirm.
11 Select the 7D5_0115.bin file.
The Flash System ROM confirmation menu appears.
12 Press F10 to confirm.
13 Press any key.
System ROM Flash was successful appears.
14 Verify system BIOS settings. See Verifying BIOS Settings on page 10.
15 From the File menu, select Save Changes and Exit.
Verifying BIOS Settings
You do not normally need to adjust BIOS settings on your workstation. BIOS
settings for the workstation are provided here for informational purposes only.
To enter the system BIOS, press F10 while booting the workstation.
WARNING Before installing Red Hat
®
Linux, it is recommended that you verify
the workstation's BIOS settings. If the storage SATA emulation option is not set
correctly (to Separate IDE Controller), you must redo Red Hat Linux installation.
The following table lists the proper Autodesk certified BIOS settings. Items
not listed are set to their default factory settings.
ValueItemBIOS Menu
Separate IDE Con-
troller
SATA EmulationStorage, Storage options
Optical Drive USB
Device Hard Drive,
Boot OrderStorage
Integrated SATA
10 | Chapter 1 Introduction