Setup guide

For workflow information related to the HP xw8400 running on Linux for
Incinerator, refer to the Autodesk Incinerator 2011 Installation and User Guide.
To install Lustre on an HP xw8400 workstation:
1 Review the guidelines for working with hardware components. See
Hardware Configuration Guidelines on page 7.
2 Connect all peripherals (mouse, keyboard, graphics monitor, storage,
etc.) to each workstation in your workgroup, and connect each
workstation to the network. See Connecting Peripherals on page 17.
3 Connect your workstation to Autodesk
®
Stone
®
Direct storage. See the
Installation and Configuration Guide.
4 Connect your Master or HD Station to a Slave Renderer, a control surface,
tablet, and video I/O components. See Connecting System Components
on page 31.
NOTE The Slave Renderer is not used in Incinerator configurations.
5 Perform the procedures in the Autodesk Lustre 2011 Software Installation
Guide or the Autodesk Incinerator 2011 Installation and User Guide to install
and license Lustre and Incinerator.
Related Documentation
The following table describes the documentation associated with your
application. For a detailed list of the latest documentation, see your release
notes.
ProvidesUser Guides
Detailed instructions on using the software.Autodesk Lustre 2011 User Guide
Detailed instructions on using the Autodesk
control surface and the Tangent CP100.
Autodesk Control Surface User Guide
A list of the new features for this release.Autodesk Lustre 2011 New Features
Guide
A list of the most frequently used hot keys.Autodesk Lustre 2011 Hot Keys Card
A complete list of documentation and informa-
tion on late-breaking features.
Autodesk Lustre 2011 Release Notes
6 | Chapter 1 Introduction