Operating instructions

1-18 DS25 Owner’s Guide
1.10 Storage Subsystem
The system comes with a six-slot storage subsystem that holds 1-inch
drives.
You can install up to six 1-inch universal hard drives in the storage disk cage.
See Chapter 4 for installation and swap procedures.
Figure 1–10 Storage Cage
MR0296A
The storage system backplane contains on-board multimode terminators that
provide LVD (low voltage differential) termination to the bus when all devices
are LVD. If an SE (single-ended) device is installed in the backplane, the ter-
minators automatically switch to SE mode termination. All devices on the bus
will operate in SE mode and all transactions will be subject to SE speed and
length limitations.