Operating instructions

show version command, 5-18
Side cover, removing, 4-11
Slot numbers
PCI, 4-22
Snoop mode, 6-7
Soft bypass mode, 6-7
Special characters, SRM console, 5-8
Specifications, 8-1
SRM
console password, 2-23
console password clearing, 2-28
SRM console
command syntax, 5-7
device naming, 2-19
invoking, 5-4
overview, 5-2
power-up display, 2-6
returning to from RMC, 5-4
setting environment variables, 5-46
special characters, 5-8
SRM console commands
clear password, 2-28
login, 2-26
set password, 2-23
set secure, 2-25
show boot*, 2-13
show device, 2-18
show memory, 2-20
SRM console commands, listed, 5-5
SRM console password
clearing, 5-45
SRM console prompt, 2-10, 5-2
SRM environment variables, setting, 2-21
SROM
power-up display, 2-5
power-up messages, 2-4
status command (RMC), 6-14, 6-40
stop command, 5-25
Storage
hard drive, 1-18
Storage subsystem, 1-18
System
fatal errors, 7-5
keys, 1-19
warning messages, 7-4
System chassis
components, 1-3
front view, 1-4
System enclosures, 1-2
System motherboard
block diagram, 1-10
T
Terminal setup (RMC), 6-9
test command, 5-23
Thermal problems, 7-10
Through mode (RMC), 6-5
Tools for installation, 4-1
Top cover, removing, 4-13
Troubleshooting
boot problems, 7-8
failures reported by console, 7-7
failures reported by operating system, 7-
11
memory problems, 7-12
PCI bus problems, 7-13
power problems, 7-6
RMC, 6-41
SCSI problems, 7-14
thermal problems, 7-10
with beep codes, 7-2
Tru64 UNIX
booting, 3-13
booting from SCSI disk, 3-13
booting over the network, 3-16
installing, 3-18
text-based installation display, 3-18
tt_allow_login environment variable, 5-63
U
UART ports, 6-5
Updating firmware, 2-29, 4-40, 5-27, 5-29, 7-
18
User mode
returning to, 5-45
W
Warning messages
system, 7-4
Index-6