Operating instructions

hangup command, 6-21
local mode, 6-5
logic, 6-3
operating modes, 6-4
overview, 6-2
PIC processor, 6-3
quit command, 6-11
remote power on/off, 6-18
remote reset, 6-19
resetting to factory defaults, 6-25
snoop mode, 6-7
soft bypass mode, 6-7
status command, 6-14
through mode, 6-5
troubleshooting, 6-41
RMC commands
clear alert, 6-29
clear port, 6-30
disable alert, 6-30
disable remote, 6-30
enable alert, 6-31
enable remote, 6-32
env, 6-32
halt in, 6-33
halt out, 6-33
hangup, 6-33
help or ?, 6-34
power off, 6-34
power on, 6-34
quit, 6-35
reset, 6-35
send alert, 6-35
set alert, 6-36
set com1_mode, 6-36
set dial, 6-38
set escape, 6-38
set init, 6-39
set logout, 6-39
set password, 6-40
set user, 6-40
status, 6-40
RMC firmware, updating, 2-32
RMC jumpers
default positions, 6-27
S
SCSI bus length, 4-38
SCSI controller IDs, 5-60
SCSI devices, speed of, 5-59
SCSI expansion, 4-38
SCSI ID orientation
six-slot, 4-34
SCSI option
installing, 4-27
SCSI problems, 7-14
SCSI terminators, enabling, 5-61
Secure function commands, 5-38
Secure function commands, 2-22
Secure mode, setting SRM to, 2-25
Secure mode, setting SRM to, 5-41
Security
setting console, 2-22, 5-38
Security features, turning off, 2-26
send alert command (RMC), 6-35
set alert command (RMC), 6-36
set com1_mode command (RMC), 6-36
set command, 5-46
set dial command (RMC), 6-38
set escape command (RMC), 6-38
set init command (RMC), 6-39
set logout command (RMC), 6-39
set password command, 5-39
set password command (RMC), 6-40
set password command (SRM), 2-23
set secure command, 5-41
set secure command (SRM), 2-25
set user command (RMC), 6-40
Setting boot options, 3-2
Setting SRM environment variables, 2-21
Shared RAM, 6-3
show boot* command (SRM), 2-13
show command, 5-46
show command (SRM), 2-12
show config command, 5-12
show cpu command, 5-19
show device command, 5-15
show device command (SRM), 2-18
show memory command, 5-16
show memory command (SRM), 2-20
show pal command, 5-20
show power command, 5-17
Index-5