Operating instructions

7.5 Boot Problems
Table 7–7 Troubleshooting Boot Problems
Problem/Possible Cause Action
Operating system (OS)
software is not installed on the
Install the operating system and license key.
hard disk drive.
Target boot device is not listed
in the SRM show device or
show config command.
Check the cables. Are the cables oriented
properly and not cocked? Are there bent pins?
Check all the SCSI devices for incorrect or
conflicting IDs. Refer to the device’s
documentation.
SCSI termination: The SCSI bus must be
terminated at the end of the internal cable
and at the last external SCSI peripheral.
System cannot find the boot
device.
Use the SRM show config and show device
commands. Use the displayed information to
identify target devices for the boot command,
and verify that the system sees all of the
installed devices. If you are attempting to use
bootp, first set the following variables as
shown:
P00>>>set ewa0_inet_init BOOTP
P00>>>set ewa0_protocols BOOTP
7-8 DS25 Owner’s Guide