Operating instructions

In Table 7–2 and Table 7–3, the green
power LED
is On in all cases except
for two. These two cases are indicated in the table. In Table 7–4 the green
power LED is always Off (
= On / = Off).
Table 7–2 System Warning Messages
LED 1 LED 2 LED 3 LED 4 Problem Condition
PS0 failed
PS1 failed
PS2 failed
Warning – Use the RMC to view
specific failure ( See Chapter 6).
Table 7–3 System Power-Up Messages
LED 1 LED 2 LED 3 LED 4 Power-Up Message
RMC power-up done
5 volt aux (No green LED
)
System down (No green LED
)
Bulk OK
System DC OK
System up
Verify fan speed
Bad RMC flash
NOTE: If the RMC flash is bad, the system will still come up; however, the bad
RMC flash LED will remain lit until a new RMC flash image is loaded.
RMC will not have full functionality, use COM2 or VGA display to
flash the RMC.
7-4 DS25 Owner’s Guide