Operating instructions

1
7.1 Error Beep Codes
Audible beep codes announce errors encountered while the system is
powering up. For example, if the firmware in flash ROM is unavailable,
you would hear a 1-1-4 beep code (one beep, a pause, a another beep, a
pause, and a burst of four beeps). Table 7–1 identifies the error beep
codes.
Table 7–1 Error Beep Codes
Beeps Message/Meaning
1-1-4
SROM code is unable to load the console
code; a flash ROM header area or
checksum error has been detected. See
Section 3.4.1.
SROM code has completed execution.
System jumps to SRM console. You should
start to see SRM messages. If no messages
are displayed, there is a problem. See
Section 3.4.1.
2-1-2 Configuration error on CPU n (n is 0, 1) or
system configuration error(s). The system
will still power up. Contact your service
provider.
1-2-4
Back-up cache (B-cache) error. A CPU is
bad. Contact your service provider.
1-3-3
No usable memory detected. Some memory
DIMMs may not be seated properly, or
some DIMM sets may be faulty.
7-2 DS25 Owner’s Guide