Operating instructions

5 BCOM Gigabit 5703c ega0.0.0.5.2 00-02-A5-20-7F-AC
Slot Option Hose 3, Bus 0, PCI - 66 MHz
1 ELSA GLoria Synergy vga0.0.0.1.3
6 Yukon PCI Hot-Plug C
P00>>>
Firmware. Version numbers of the SRM console, PALcode, serial ROM,
RMC ROM, and RMC flash ROM
Processors. Processors present, processor version and clock speed, and
amount of backup cache
Core logic. Version numbers of the chips that form the interconnect on
the system board
Memory. Memory arrays and memory size
This part of the command output shows the PCI buses.
The “Slot” column lists the slots (logical IDs) seen by the system. Logical
IDs identify both installed PCI cards and onboard chips. In this example,
the onboard chips include the Yukon PCI hot-plug controller and the Acer
Labs M1543C IDE.
The logical IDs do not correspond directly to the physical slots into which
the devices are installed.
NOTE: The naming of devices (for example,dqa.0.0.16.0) follows the con-
ventions given in Table 5–5.
Hose 0, Bus 0, PCI
Slot 7 Onboard Acer chip. Provides bridge to Bus 1
Slot 8 Onboard Ethernet
Slot 12 Onboard PCI hot-plug controller
Slot 16 Onboard Acer chip
Hose 0, Bus 1
Hose 2, Bus 0, PCI
Slots 1/0, 1/1 Adaptec controller.
Slot 5 Broadcom gigabit Ethernet controller
Hose 3, Bus 0, PCI
Slot 1 ELSA Gloria Synergy
Slot 6 Onboard PCI hot-plug controller
The slots in Example 5–2 are explained below.
Using the SRM Console 5-13