Operating instructions

CAUTION: Do not remove a drive that is in operation. A drive should be re-
moved only when its Activity LED is off.
Installing Drives
1. Insert the drive carrier into the cage with the front handle
fully open.
With the carrier resting on top of the rail guides of the cage, slide the car-
rier in until it stops.
2. Push the handle
in to make the backplane connection and to secure it
into the cage.
Removing Drives
1. To remove the carrier, press the colored rubber button
in to release the
handle.
2. Pull the handle
forward to release the SCSI connection and then pull the
drive out of the cage.
Verification
If you hot-swapped a drive, the Activity LED on the new drive flashes when the
drive is inserted. If the system was powered off when you installed the drive,
the LED flashes on system power-up.
Also, use the show device command to verify that the system sees the new
drive.
Configuring and Installing Components 4-33