Operating instructions

Figure 4–13 Installing DIMMs
1
1
2
CAT0124A
1. To install the DIMM
, align the notches on the gold fingers with the con-
nector keys as shown in Figure 4–13.
2. Shut down the operating system and turn off power to the system. Unplug
the power cord from each power supply.
3. Use Table 4–2 and the Memory Configuration Rules for determining where
sets of memory DIMMs should be installed.
4. To install the DIMM
, align the notches on the gold fingers with the con-
nector keys as shown in Figure 4–13.
5. Secure the DIMM with the clips
on the DIMM slot.
Verification
1. Turn on power to the system.
2. At the SRM prompt, issue the show memory command to display the
amount of memory in each array and the total amount of memory in the
system.
4-18 DS25 Owner’s Guide