Operating instructions

Figure 4–2 Installing the Lower Panel

MR0299

Conversion Procedure

1. Remove the top cover from the rack system by loosening the captive screw

and sliding the cover to the rear. Set aside the cover; it will not be reused.

2. Rotate the system chassis so that the operator control panel (OCP)

is at

the lower right.

3. Place the lower panel slide feet up

, with the large tabs to the right as you

face the front of the unit. Slide the panel to the left and seat it firmly. In-

sert a thumbscrew through the tab into the insert and tighten. See Figure

4–2.

4. Turn the chassis over and rest it on the slide feet. The OCP should now be

at the upper left as you face the chassis.

Configuring and Installing Components 4-5