Technical data

Connect the SCSI cable to the system unit and to the expansion box as follows:
1. Set the on/off switches on the system unit and the expansion box to the off
(O) position.
2. Make sure that you have set the correct SCSI ID for each device in the
expansion box. See Section 4.4.2 for information on selecting the available
SCSI IDs.
3. Connect one end of the 50-pin to 50-pin cable, supplied with the expansion
box, to the SCSI port on the system unit. Close the bail lock loops. See
Figure 4–2.
4. Connect the other end of the 50-pin to 50-pin cable to either of the SCSI
ports on the expansion box. Close the bail lock loops.
5. Connect the SCSI terminator to the other SCSI port on the expansion box.
Close the bail lock loops.
6. Connect the power cord to the expansion box.
7. Connect the other end of the power cord to the same grounded power strip
or electrical circuit.
8. Set the on/off switch on the expansion box to the on (|) position.
9. Set the on/off switch on the system unit to the on (|) position.
10. Check the system to ensure that it recognizes the connection. See
Section 4.4.5 for information on checking expansion box connections.
4–8 Hardware Options