Technical data

3.7 Removing the System Unit from a Network
The following subsections describe how to remove the system unit from a
network.
Note
Before removing the system unit from a network:
• Get the approval of the network coordinator.
• See the operating system documentation for information on the
shutdown procedures before stopping or turning off the system.
• If the system is the server in a network, do not turn off, halt or
restart the system without notifying the other network members.
3.7.1 Removing the System Unit from a ThinWire Ethernet Cable
To remove the system unit from a ThinWire Ethernet cable, follow these steps:
1. Set the on/off switch on the back of the system unit to the off (O) position.
Caution
Disconnecting the ThinWire Ethernet terminator or the ThinWire
Ethernet cable connectors from the T-connector may cause disruptions
to network communications.
2. Disconnect the center of the T-connector from the ThinWire Ethernet
connector on the back of the system unit. See Figure 3–6, A.
3. Add the terminator to the T-connector and reinstall the T-connector. See
Figure 3–6, B.
3–12 Network Information