Technical data

2.3.3 Inserting a QIC Tape into the TZK10
To insert a QIC tape into the TZK10, follow these steps:
1. Press the eject button to open the door on the front of the TZK10 (see
Figure 2–6). The door partially opens.
2. Open the door fully.
3. Insert the QIC tape into the TZK10. Figure 2–6 shows the correct
orientation of the tape as you insert it. Slide the tape in until you feel
resistance.
4. Close the door.
When you insert the tape correctly, the LED turns green, then flashes green
while the TZK10 makes several whirring sounds. Finally, the sounds stop and
the LED stays green. You can now send operating system commands to the
TZK10 QIC tape drive.
If the LED turns amber, see the VAX 4000 Model 100A Troubleshooting and
Diagnostics Information manual.
2–14 Internal System Devices