Technical data

C.3.4 Setting the Node Name
After entering the DUP driver utility for a specified device, you can examine
and set the node name for the device as follows.
1. At the PARAMS> prompt, enter SHOW NODENAME to check the node name of the
ISE to which you are currently connected.
2. Enter SET NODENAME SYSDSK (or enter the desired alphanumeric node name
of up to eight characters).
3. Enter SHOW NODENAME to verify the new node name.
This shows the steps for changing the node name of a specified device from the
factory-supplied name to SYSDSK.
PARAMS>SHOW NODENAME
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
NODENAME R7CZZC RF73 String Ascii B
PARAMS>SET NODENAME SYSDSK
PARAMS>SHOW NODENAME
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
NODENAME SYSDSK RF73 String Ascii B
C.3.5 Setting the System ID
Note
This parameter is modified only when replacing a device. Only Digital
service representatives and licensed self-maintenance customers should
remove devices. All parameters for the replacement device should be
programmed to match those of the original device.
After entering the DUP driver utility for a specified device, you can examine
and set the system ID for the device as follows.
1. At the PARAMS> prompt, enter SHOW SYSTEMID to check the system ID of the
device to which you are currently connected.
2. Enter SET SYSTEMID System ID (enter the desired serial number-based
system ID).
3. Enter SHOW SYSTEMID to verify the new system ID.
Programming Parameters for DSSI Devices C–9