Technical data

PARAMS>SHOW ALLCLASS
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
ALLCLASS 0 0 Byte Dec B
PARAMS>SET ALLCLASS 2
PARAMS>SHOW ALLCLASS
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
ALLCLASS 2 0 Byte Dec B
C.3.3 Setting the Unit Number
After entering the DUP driver utility for a specified device, you can examine
and set the unit number for the device as follows.
1. At the PARAMS> prompt, enter SHOW UNITNUM to check the unit number of
the ISE to which you are currently connected.
2. Enter SET UNITNUM 10 (or enter the unit number you desire).
3. Enter SET FORCEUNI 0 to override the default unit number value supplied
by the bus node ID plug.
4. Enter SHOW UNITNUM to verify the new unit number.
5. Enter SHOW FORCEUNI to verify that the current value for the FORCEUNI
parameter is 0.
This shows the steps for changing the unit number of a specified device
from 0 to 10.
PARAMS>SHOW UNITNUM
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
UNITNUM 0 0 Word Dec U
PARAMS>SET UNITNUM 10
PARAMS>SET FORCEUNI 0
PARAMS>SHOW UNITNUM
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
UNITNUM 10 0 Word Dec U
PARAMS>SHOW FORCEUNI
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
FORCEUNI 0 1 Boolean 0/1 U
6. Label the device with its unit number, using the unit number labels
shipped with your system.
C–8 Programming Parameters for DSSI Devices