Service manual

Operating the System Remotely C-15
C.1.4 Dial-Out Alerts
The RCM can be configured to automatically dial out through the modem
(usually to a paging service) when it detects a power failure within the system.
When a dial-out alert is triggered, the RCM initializes the modem for dial-out,
sends the dial-out string, hangs up the modem, and reconfigures the modem for
dial-in. The RCM and modem must continue to be powered, and the phone line
must remain active, for the dial-out alert function to operate.
Example C-3 Configuring the Modem for Dial-Out Alerts
P00>>> set rcm_dialout “ATDT string#; ” ➊
RCM>enable
RCM>status
.
.
Remote Access: ENABLE
➋
.
RCM>alert_ena
➌
Example C-4 Typical RCM Dial-Out Command
P00>>> set rcm_dialout “ATXDT9,15085553333,,,,,,5085553332#;”
Use the show command to verify the RCM dial-out string:
P00>>> show rcm_dialout
rcm_dialout ATXDT9,15085553333,,,,,,5085553332#;