Service manual

Operating the System Remotely C-13
If the escape sequence entered exceeds 15 characters, the command fails with the
message:
*** ERROR ***
When changing the default escape sequence, avoid using special characters that are
used by the system’s terminal emulator or applications.
Control characters are not echoed when entering the escape sequence. To verify the
complete escape sequence, use the status command.
C.1.3.14 setpass
The setpass command allows the user to change the modem access password that is
prompted for at the beginning of a modem session. The password is stored in the
module’s on-board NVRAM.
RCM>setpass
new pass>*********
RCM>
The maximum password length is 15 characters. If the password entered exceeds 15
characters, the command fails with the message:
*** ERROR ***
The minimum password length is one character, followed by a carriage return. If
only a carriage return is entered, the command fails with the message:
*** ERROR - illegal password ***
If the user has forgotten the password, a new password can be entered.