Service manual

Operating the System Remotely C-9
C.1.3.4 disable
The disable command disables remote access to the RCM modem port.
RCM>disable
The module’s remote access default state is DISABLED. The modem enable state is
nonvolatile. When the modem is disabled, it remains disabled until the enable
command is issued. If a modem connection is in progress, entering the disable
command terminates it.
C.1.3.5 enable
The enable command enables remote access to the RCM modem port. It can take up
to 10 seconds for the enable command to be executed.
RCM>enable
The module’s remote access default state is DISABLED.
The modem enable state is nonvolatile. When the modem is enabled, it remains
enabled until the disable command is issued.
The enable command can fail for two reasons:
• There is no modem access password configured.
• The modem is not connected or is not working properly.
If the enable command fails, the following message is displayed:
*** ERROR - enable failed ***
C.1.3.6 hangup
The hangup command terminates the modem session. When this command is
issued, the remote user is disconnected from the server. This command can be
issued from either the local or remote console.
RCM>hangup