Service manual

SRM Console Commands and Environment Variables B-3
Table B-1 Summary of SRM Console Commands (Continued)
Command Function
man Displays information about the specified console command.
more Displays a file one screen at a time.
prcache Initializes and displays status of the PCI NVRAM.
set envar Sets or modifies the value of an environment variable.
set host Connects to an MSCP DUP server on a DSSI device.
set rcm_dialout Sets a modem dialout string.
show envar Displays the state of the specified environment variable.
show config Displays the configuration at the last system initialization.
show cpu Displays the state of each processor in the system.
show device Displays a list of controllers and their devices in the system.
show fru Displays the serial number and revision level of system bus
options.
show memory Displays memory module information.
show network Displays the state of network devices in the system.
show pal Displays the version of the privileged architecture library code
(PALcode).
show power Displays information about the power supplies, system fans,
CPU fans, and temperature.
show
rcm_dialout
Displays the modem dialout string.
show version Displays the version of the console program.
start Starts a program that was previously loaded on the processor
specified.
stop Halts the specified processor. (Same as halt.)
test Runs firmware diagnostics for the system.