Service manual

Removal and Replacement 7-41
Removal
1. Shut down the operating system and power down the system.
2. Expose the system drawer.
3. Expose the PCI bus card cage. Remove three Phillips head screws holding the
cover in place and slide it off the drawer.
4. Remove the faulty option. Disconnect cables connected to the option. Unscrew
the small Phillips head screw securing the option to the card cage. Slide the
option from the card cage.
Replacement
Reverse the steps in the Removal procedure.
Verification — DIGITAL UNIX and OpenVMS Systems
1. Power up the system (press the Halt button if necessary to bring up the SRM
console) and run the ECU to restore EISA configuration data.
2. Issue the show config command or show device command at the console
prompt to verify that the system sees the option you replaced.
3. Run any diagnostic appropriate for the option you replaced.
Verification — Windows NT Systems
1. Start AlphaBIOS Setup, select Display System Configuration, and press
Enter.
2. Using the arrow keys, select PCI Configuration or EISA Configuration to
determine that the new option is listed.