Service manual

Removal and Replacement 7-17
Exposing the System Drawer
1. Open the front door and remove it by lifting and pulling it away from the
system.
2. Remove the top cover. Unscrew the two Phillips head screws midway up on
each side of the pedestal, tilt the cover up, and lift it away from the frame.
3. Remove the system bus card cage cover at the back of the pedestal if you are
replacing any of the following: CPU, memory, power control module, system
bus to PCI bus module, system motherboard, cables that attach to the system
motherboard, or a system fan. To remove the cover, unscrew the two Phillips
head screws and slide the cover off the drawer.
4. Remove the PCI bus card cage cover at the back of the pedestal if you are
replacing any of the following: PCI or EISA option, server control module, PCI
motherboard, cables attached to the PCI motherboard. To remove the cover,
unscrew the three Phillips head screws holding the cover to the side of the
drawer and slide the cover off the drawer.
5. Remove the pedestal tray as described below if you are replacing any of the
following: system fan, power supply, power cables.
Removing the Pedestal Tray
1. Remove the tray cover by loosening the screws at the back of the tray.
2. Disconnect the cables from the OCP and any optional SCSI device from the
bulkhead connector in the rear right corner of the tray.
3. Unscrew the Phillips head screw holding the bulkhead to the tray.
4. Unscrew the two Phillips head retaining screws and slide the tray off the drawer.