User's Manual

Paper feed guide assembly
1. Remove the following components:
●
All covers (see
Covers on page 69)
●
Formatter (see
Formatter on page 80)
●
ECU (see
Engine control unit (ECU) on page 88)
●
Access plate (see
Access plate on page 96).
●
Fuser (see
Fuser on page 83)
●
High-voltage power supply (see
High-voltage power supply on page 97)
2. Lift one non-captive grounding spring (see callout 11 in
Figure 5-36 Grounding-spring locations
on page 102 out of the device.
3. Loosen the grounding wire from the routing guides (callout 1).
CAUTION Do not bend or remove the grounding wire.
4. Remove two screws (callout 2).
2
1
Figure 5-38 Removing the paper feed guide assembly
5. On the edge of the assembly farthest from you, lift the right corner up, twist the assembly
counterclockwise, and remove the assembly from the device.
104 Chapter 5 Removal and replacement ENWW