User's Manual

hp officejet 5100 series

technical information

doc statement / déclaration de conformité (Canada)

Le présent appareil numérique n'émet pas de bruit radioélectrique dépassant les limites

applicables aux appareils numériques de la classe B prescrites dans le Règlement sur le

brouillage radioélectrique édicté par le ministère des Communications du Canada.

This digital apparatus does not exceed the Class B limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian

Department of Communications.

notice to users of the Canadian telephone network

Notice: This equipment meets the applicable Industry Canada Terminal Equipment

Technical Specifications. This is confirmed by the registration number. The abbreviation,

IC, before the registration number signifies that registration was performed based on a

Declaration of Conformity indicating that Industry Canada technical specifications were

met. It does not imply that Industry Canada approved the equipment.

Note: The Ringer Equivalence Number (REN) assigned to each terminal device provides

an indication of the maximum number of terminals allowed to be connected to a telephone

interface. The termination on an interface may consist of any combination of devices

subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the

devices does not exceed 5.

notice to all users of the European Economic Area (EEA)

This product is designed to interwork with the analogue telephone networks in the

following countries:

Network compatibility depends on customer-selected settings, which must be reset to use

the equipment on a telephone network in a country other than where the product was

purchased. Contact the vendor or Hewlett-Packard Company if additional product support

is necessary.

This equipment has been certified by the manufacturer in accordance with Directive

1999/5/EC (annex II) for Pan-European single-terminal connection to the public switched

telephone network (PSTN). However, due to differences between the individual PSTNs

provided in different countries, the approval does not, of itself, give an unconditional

assurance of successful operation on every PSTN network termination point.

In the event of problems, you should contact your equipment supplier in the first instance.

This equipment is designed for DTMF tone dialing and loop disconnect dialing. In the

unlikely event of problems with loop disconnect dialing, it is recommended that you use

this equipment only with the DTMF tone dial setting.

Germany UK Netherlands

France Spain Italy

Belgium Luxembourg Sweden

Austria Denmark Ireland

Norway Finland Switzerland

Greece Portugal