User's Manual

How To Configure for X.25

The X.25 routing service is available on most HP routers. In the factory

default, most of the X.25 parameters are set to default values that may

be acceptable for your application. For a minimal X.25 configuration,

you will need to enter one of the following sets of values:

DDN PDN X.25 Point-to-Point

(PTOP)*

None

Default settings are provided

for all values needed for

minimal configuration

X.121 address of the local

port

IP address and X.121 address

of each remote port

X.121 address of the local

port

X.121 address of the remote

port

The connection ID for the

remote port

*You can specify only one PTOP circuit in Quick Configuration. If you want to specify additional circuits,

you must use the Configuration Editor (which you can access from Quick Configuration by using the

[/]

[M] Hotkey combination).

Note: The Configuration Editor provides appropriate default circuit names and

circuit group names.

For descriptions of specific X.25 parameters, refer to the Operator’s

Reference.

Quick

Configuration

How To Use Quick Configuration

How To Configure for X.25

3-17