User's Manual
Set-Up Requirements for Quick Remote
The following is needed to enable Quick Remote operation:
The central router on which you are going to create the Quick
Remote configuration(s) must already be configured for HP Point-to-
Point routing on the WAN ports that you will use for Quick Remote
access from remote routers. (The Quick Remote configurations that
you create are assigned to these WAN ports on the central router for
downloading to remote routers, but do not affect the configuration
of these ports.)
An active HP Point-to-Point WAN link must exist between a WAN
port on a remote router and a WAN port on a central HP router.
A minimal IP and/or IPX configuration must be stored in Quick
Remote on the central router for the WAN port linked to a WAN port
on the remote router
The remote HP router must be configured to the factory default
prior to power-up or rebooting
Note ‘‘Factory default’’ is the state of the router configuration either when the
router is shipped from the factory or when you use the Clear/Reset
button combination (described in the installation manual) to clear the
configuration and reboot the router.
How To Use Quick Remote
Introducing Quick Remote
8-4