User's Manual

Syntax
zput config filename [append][format] transfer router
configuration
zput NCL-command filename[append][format]
store display
command output
where:
filename is the name of a file on the remote PC host to store
the output from this router.
NCL-command is an NCL display command string on this router.
Possible commands are listed above and described earlier in this
chapter. If the command has parameters and thus includes a
space, then enclose the command string in double quotes.
[append] (optional) specifies whether to append any existing
file of the same name as filename, either of the following:
0(the default) prevents appending.
1 allows appending.
[format](optional) selects the file formatting required by the
host, either:
0 (the default) ends lines with carriage returns and line feeds
(CR LF), as needed by most PCs.
1 ends lines with line feeds only (LF).
Examples
zput config inter1.cfg
zput "rgetr 10.1.2.1 public" pr1table.txt
In response, a status window temporarily appears to monitor
transfer data and progress.
How To Use the Network Control Language (NCL) Commands To Manage a Router
Using PC Modem Access to Transfer Configuration and NCL Display
7-34