Installation Manual

1. Slide the AUI retainer (included) onto the connector posts on a

transceiver (also called a “MAU”) that corresponds to your type of

network cabling, or on an AUI cable that is attached to a transceiver

(whichever will attach directly to the router).

2. Plug the transceiver or cable into the Ethernet/802.3 port on the

router.

3. Secure the retainer and the transceiver or cable to the router with

the retainer’s screws.

4. Connect the network cable to the transceiver.

If your router’s LAN port(s) have both an AUI interface and a BNC

interface, refer to the note on page 1-11

Transceiver or

AUI cable con-

nector

Connector post

AUI LAN port on router

AUI retainer

Figure 1-10.Installing the AUI Retainer

Installation

Phase 3: Prepare the Router Hardware

1-13