Installation Manual
3. After the Self-test LED turns off:
• The port status LEDs for the network interfaces (WAN, 802.3
Ethernet, etc.) will indicate the current operating state of each
interface on the router. (If you need to interpret the LEDs at this
time, refer to ‘‘Meanings of Port Status LEDs’’ on page 2-9.)
• The console, if installed, will display either the following line of
text on your console’s display:
Waiting for speed sense.
or a string of random characters of about the same length as the
preceding line.
Note
The remainder of this procedure assumes that a console is connected to
the router’s console port, either directly or through a modem.
27290A R outerBR
Net Fai l
Wrap
Sig De t
Rx
Ring O P
Thru
Tx
See Ma nual
Pwr
Rese t
Self-t est
Fault
Clea r
~ LI NE 5 0/ 60 H Z
100-120 VAC . 1. 00 A
200-240 VAC . 0. 60 A
Cons ole Po rt
RS-2 32
BNC AUI
Rx
Tx
Net Fai l
Enab led
Ethern et/802.3 Po rt 1
BNC AUI
Rx
Tx
Net Fai l
Enab led
Ethern et/802.3 Po rt 2
BNC AUI
Rx
Tx
Net Fai l
Enab led
Ethern et/802.3 Po rt 3
BNC AUI
Rx
Tx
Net Fai l
Enab led
Ethern et/802.3 Po rt 4
A
SO POPI
Enable d
Assem bly No . 27 29 0-60001
SI
MIC Por ts
MIC A
Optica l By pass
MIC B
B
FDDI Por t
Power and
Self-Test
LEDs
Figure 1-20.Example of Power and Self-Test LED Positions for Double-Height Models
Installation
Phase 3: Prepare the Router Hardware
1-24