User's Manual

How To Use Zget To Load the Configuration to
a Router
Use NCL’s Zget command to upload the router configuration previously
stored as a file on the PC connected to the router as a console.
Note Zget overwrites the router’s current configuration with the uploaded
configuration.
This procedure describes the use of Zput with PROCOMM PLUS. The
procedure is different when used with other terminal emulators.
Preparation
You must have either acquired the configuration from another source or
used Zput earlier to download the configuration to the PC host (see page
7-33). Run the PROCOMM PLUS terminal emulation program. Start a
router console session with the manager password.
To upload the configuration to the router:
1. Enter the Zget command:
zget [Enter]
2. Press [Pg Up] to display the “Upload Protocols” window.
3. Type z to select the “ZMODEM“ option and to display the “Send
ZMODEM“ window.
4. Enter the name of the file containing the configuration you want to
upload. End with [Enter] to begin uploading.
How To Use the Network Control Language (NCL) Commands To Manage a Router
Using PC Modem Access to Transfer Configuration and NCL Display
7-36