Installation Manual

Telnet
Telnet is an upper-layer service that allows you to interact with a remote
node’s console interface, by establishing a virtual terminal connection.
You make a console connection from an HP router that has IP routing
and a Telnet session configured to a router or end node that has Telnet
service and is suspected of not routing successfully.
1. From the Main menu, select the Network Control Language
Interpreter (NCL). The NCL prompt then appears at the bottom of
the screen. (See figure 3-1 on page 3-16.)
2. At the NCL prompt, enter the Telnet command:
telnet x.x.x.x
where x.x.x.x is the IP address of the remote node in dotted decimal
notation.
3. Once the connection is established, Telnet passes your keystrokes to
the remote system. If the remote system is another HP router:
a. You will see the system name of the remote node as the NCL
prompt at the bottom of your display. Check the event log or rout-
ing tables of the remote node as you do for your own router. Use
the Exit command to leave NCL and return to the remote node’s
Main menu:
exit [Return]
b. To disconnect the Telnet session, use the Logout option from the
remote node’s Main menu. When you are prompted with:
Do you want to disconnect? [Y/N:]
press [Y] for ‘‘yes’’. The remote node is disconnected, the Telnet
session ends, and your own system name appears in the the
display.
If the remote system is not another HP router, then type the
appropriate commands to interact with that system and to
disconnect Telnet.
4. Use the Exit command to leave NCL and return to the Main menu:
exit [Return]
Troubleshooting
3
Troubleshooting
Diagnostic Tests
3-19