Installation Manual

4-17
Troubleshooting
Inserting the HP Internet Router Module into an HP Remote 2C
Maintenance
Inserting the HP Internet Router Module
into an HP Remote 2C
In the topology below, HP does not recommend configuring the HP Internet
Router Module for bridging. Instead configure the router to route IP, IPX, and
Appletalk protocols. This is because bridging forwards multicast and broad-
cast packets from the 100 Mbps network to the much slower T1 or ISDN lines.
This will overload the WAN link with traffic. In routing mode, the Router will
not forward multicast and broadcast packets off of the network.
Service Note Numbers
J3200A-02A
J3201A-02A
J3202A-02A
J3203A-02A
J3204A-02A
J3205A-02A
J3138A-01
To A 100VG Network
Back of Remote 2C
HP Internet Router
Module (in either slot
of the Remote 2C)
J3138.bk Page 17 Wednesday, March 18, 1998 6:07 PM