Installation Manual

3-20
Configuring the HP AdvanceStack Internet Router
Verifying Network Connectivity
Configuration
Verifying Network Connectivity
After you have installed and configured the router, you can use the following
commands in user EXEC mode to verify network connectivity:
■
telnet—Logs in to a remote node
■ ping—Sends a special datagram to the destination device, then waits for
a reply datagram from that device
■ trace—Discovers the routes that packets take when traveling from one
router to another
If there is a problem with network connectivity, refer to the section “Reading
the LEDs” in chapter 4 “Troubleshooting” and check the cable connections. If
there is still a problem, check the router configuration.
Getting More Information
For more information about router software configuration, refer to the
Cisco IOS configuration guide and command reference publications. These
publications are available from the HP web site as described on page 1-6.
J3138.bk Page 20 Wednesday, March 18, 1998 6:07 PM