Installation Manual

3-6
Configuring the HP AdvanceStack Internet Router
Configuring the Router for the First Time
Configuration
6. Enter an enable secret password:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret: pail
The enable password is used when there is no enable secret
and when using older software and some boot images.
7. Enter the enable and virtual terminal passwords:
Enter enable password: shovel
Enter virtual terminal password: vterm1
8. Press Return to accept Simple Network Management Protocol (SNMP)
management, or enter no to refuse it:
Configure SNMP Network Management? [yes]: no
9. In the following example, the router is configured for AppleTalk, Internet
Protocol (IP), and Internetwork Packet Exchange (IPX). Configure the
appropriate protocols for your router:
Configure Vines? [no]:
Configure LAT? [no]:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure DECnet? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure CLNS? [no]:
Configure bridging? [no]:
Configure IPX? [no]: yes
Configure XNS? [no]:
Configure Apollo? [no]:
10. Next, to configure the ISDN BRI port, enter the ISDN BRI switch type. The
switch type appropriate for the router depends on the ISDN service
provider’s equipment. Table 3-1 lists the ISDN switch types.
Enter ISDN BRI Switch Type [none]: basic-5ess
J3138.bk Page 6 Wednesday, March 18, 1998 6:07 PM