Installation Manual

2-13
Installing the HP AdvanceStack Internet Router
Connecting to the Network
Installation
Connecting a Modem to the Auxiliary Port
Take the following steps to connect a modem to the auxiliary port on the
router:
1. Use an RJ-45 roll-over cable with an RJ-45-to-DB-25 or RJ-45-to-DB-9
adapter to connect a modem to the auxiliary port. The adapters provided
by HP are labeled “Modem”.
Figure 2-4.
Connecting a Modem to the Auxiliary Port
2. Make sure that your modem and the auxiliary port on the router are
configured for the same transmission speed (38400 baud is typical) and
hardware flow control with Data Carrier Detect (DCD) and Data Terminal
Ready (DTR) operations.
J3138.bk Page 13 Wednesday, March 18, 1998 6:07 PM