Reference Guide

ZCOM Tables and Data Structures

Physical Terminal Tables

Chapter 374

The content of this field is as follows:

Figure 3-4 Terminal Status Field PTDRST

The IN bit indicates whether the terminal is considered as part of the

current configuration. It is initialized by TTGEN and maintained by the

driver. The EN and AC bits represent the current status of the terminal.

They are initialized by TTGEN and maintained by the driver. They are

reflected in the opposite sense by DS and IA on the interface card and in

PTFWST.

When the ZCOM subsystem starts up, the driver sets the AV bit if the

terminal is successfully initialized.

PTFWST - Firmware terminal status

This word contains the TMSTAT and TMSTT2 bytes from the Mux (via

$STDT buffer)

Figure 3-5 Firmware Terminal Status PTFWST

The status in bits 7-0 is copied from the $STDT buffer. These bits

represent the field TMSTT2 from the interface terminal table.

15 10987654321011121314

EN AC

IN -

EN -

Terminal has been initialized (ZCOM_PTDRST_INT)

Terminal is enabled (ZCOM_PTDRST_ENB)

AC -

Terminal is active (ZCOM_PTDRST_ACT)

AV - Terminal is available for use

15 10987654321011121314

DS SP

DS -

SP -

Terminal is disabled

Terminal is on slow poll list

IA -

Terminal is inactive (no poll)

GP - Terminal is group polled

GP DN GA GM

DN - Terminal is down

DC - Terminal downcounter expired

GA - Group poll active

GM - Group poll master