Reference Guide

ZCOM C I/F Library Routines
ZCONFIG (3X)
Chapter 4 221
data.setterm.zaddr
ZLU of the related terminal. The “node” field is not used. For action 1 and 2, if
ZLU is non-zero, it must be an unassigned one and ZLU checksum is not
necessary. If ZLU is zero, the system chooses an arbitrary (unused) one. For
actions ZcDSC_CLEAR_TERM, ZcDSC_DELETE_TERM, and
ZcDSC_MOVE_TERM, the ZLU must be defined and the ZLU checksum
must be valid.
data.setterm.daddr
ZLU of the destination terminal. It specifies the destination PTT to which the
newly created terminal is linked. It must be a defined terminal and the
checksum must be valid. The “node” field is not used. It is used for action
ZcDSC_CREATE_LTT_ON_PTT only.
data.setterm.iftno
Interface card number (0, 1,...). It specifies to which interface card the new
terminal is linked. This field is needed for actions
ZcDSC_CREATE_LTT_PTT and ZcDSC_MOVE_TERM only.
data.setterm.portno
Port number in the interface card (0 to 7). It specifies to which port the new
terminal is linked. This field is needed for actions
ZcDSC_CREATE_LTT_PTT and ZcDSC_MOVE_TERM only.
data.setterm.subchno
Subchannel number on the port (0 to 31). It specifies the subchannel number
the terminal will communicate over. Currently, only the Z7300A card
supports subchannels. All other ACC interface card types must set this
parameter to zero. This field is needed for actions ZcDSC_CREATE_LTT_PTT
and ZcDSC_MOVE_TERM only.
data.setterm.dtype
Terminal device type. It is set up in the newly created terminal. This field is
needed for actions ZcDSC_CREATE_LTT_PTT and
ZcDSC_CREATE_LTT_ON_PTT only.
data.setterm.ltype
Logical terminal type. It is set up in the newly created terminal. This field is
needed for actions ZcDSC_CREATE_LTT_PTT and
ZcDSC_CREATE_LTT_ON_PTT only.
data.setterm.ltt