Reference Guide

ZCOM C I/F Library Routines
ZCONFIG (3X)
Chapter 4202
Configuration Data
header.config
ZCOM_ZCONFIG_PORT (port configuration)
header.action
header.tag1,
header.tag2
Any values.
data.setport.iftno
Interface card number (0, 1,...).
data.setport.portno
Port number in the interface card:
0..7 For Z7200A, Z7340A, and Z7400A ACC interface cards
0..3 For the Z7300A ACC interface card
0..1 For the Z7350A ACC interface card
data.setport.rcode
This field is for actions 1-4 only. Values are:
1 - Use configuration in interface table
2 - Use data in field \fIdata.setport.cnfg
data.setport.spare
ZcDSC_ALL_PARMS (1) - Set all operating modes
(Configuration, Baud Rate and
Port)
ZcDSC_CFG_MODE (2) - Set Configuration mode only
(Ecode, Sync, Mode, Parity)
ZcDSC_BAUD_RATE (3) - Set Baud Rate mode only
(X.Clk, S.Clk, Baud Rate)
ZcDSC_PORT_MODE (4) - Set Port mode only (Pmode)
ZcDSC_BREAK_REQ (5) - Port Break request
ZcDSC_SET_XMIT_LIMIT (6) - Modify port transmit limit
ZcDSC_ENABLE_PORT (7) - Enable a port
ZcDSC_DISABLE_PORT (8) - Disable a port