Reference Guide

ZCOM Tables and Data Structures

ZCOM Kernel Data

Chapter 3126

HPANO - HPA value of I/F card (zhpano_type)

The HPA value is setup by the DAM when HP-UX creates an instance of

the DAM for a particular Mux interface card. This field is used by the

LDM to match the Mux interface cards defined in the TTGEN

configuration file, to those actually configured in the hardware. The

format of the field is shown in Table 3-45.

In the 32-bit kernel, the HPA value is a 32-bit value. Only the lower

32-bit are kept in this field. This field will also become a 32-bit field,

followed by a 32-bit padding.

RESRVD1 - Reserved for future use.

RESRVD2 - Reserved for future use.

HLMPDA - Pointer to DAM PDA for I/F card

This is the address of the PDA for this Mux interface card and is setup by

the DAM when it initializes a row for an interface card.

HPAIFT - Pointer to ZCOM Interface table for this interface

This field is initialized to NULL during bootup. It is set up by the LDM

during ZCOM subsystem startup. It is used to retrieve the responsible

IFT from the HPA value.

HSTATUS - Status of this entry

This field contains the status indicators for the HPA entry. The DAM sets

up the status after the drivers recognize the hardware during HP-UX

system boot-up. Currently, only one bit is used (bit 15,

ZCOM_HSTATUS_ALIVE). Bit ZCOM_HSTATUS_ALIVE indicates that

the Mux card is physically present and usable.

The LDM checks this status before it communicates with the DAM. If

this bit is not set, the LDM will ignore the card. This feature is intended

for the implementation of dynamic hardware reconfiguration in HP-UX.

Table 3-45 HPA value of I/F card (HPANO)

63-32 31-28 27-18 17-14 13-12 11 10-6 5-2 1-0

All 1’s (111...) 1111 Bus

nmbr

Slot Module Pag

Set

Reg No. 00