Troubleshooting guide

Troubleshooting Guide 335795-006 3–1

HP t5000 Series Setup

(F10) Utility

Using HP t5000 Series Setup (F10) Utility

The Setup utility can be accessed only by turning the computer on

or restarting the system. To access the Setup Utility menu,

complete the following steps:

1. Turn on or restart the computer.

❏ If you are using Microsoft Windows XP Embedded, click

Start > Shut Down > Restart the Computer.

❏ If you are using Microsoft Windows CE .NET, click

Start > Shut Down > Shut Down and Restart > OK.

2. When the

F10 = Setup message displays in the task bar at the

bottom of the screen, press the

F10 key.

✎

If you do not press the F10 key while the message is displayed,

you must restart the computer again to access the utility. When

the F10 Post Screen display is set to zero seconds, it may be

necessary to press and hold

F10 on the keyboard, then power on

the computer.

3. A choice of five menu headings and five task headings

appears in the Setup Utility menu:

Menu Headings: System Information, Standard CMOS

Features, Advanced BIOS Features, Integrated Peripherals,

and Power Management Setup.