HP ProBook 5330m Notebook PC Maintenance and Service Guide

Display panel
Description Spare part number
Display bezel 650368-001
33.8 cm (13.3 in) High-Definition (HD) AntiGlare LED display (1280x800) 650397-001
NOTE: If you need to remove only the display panel, not the complete display assembly, follow the
steps in this section. To remove the complete display assembly, omit this section and follow the
procedures in
Display assembly on page 77.
Before removing the display panel, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 37).
Remove the display panel:
1. Position the computer right-side up on a flat surface, with the display open.
2. Flex the top (1) of the bezel from the inside edge until it disengages from the display back cover.
3. Flex the inside edge of the left side and the right side (2) of the bezel until they disengage from
the display back cover.
4. Flex the bottom (3) of the bezel from the inside edge until it disengages from the display back
cover.
74 Chapter 4 Removal and replacement procedures