- Hewlett-Packard Tool Storage User Manual

& Diagnostics

Information

Troubleshooting

Byte

-13

Description

17 02 Recovered data using positive offset

17 03 Recovered data using negative offset

17 05 Recovered data using previous sector ID

17 06 Recovered data without ECC; data auto-reallocated

18 00 Recovered data with ECC

18 01 Recovered data with ECC and retries applied

18 02 Recovered data with ECC and/or retries; data auto-reallocated

19 00 Defect list error

19 01 Defect list not available

19 02 Defect list error in primary list

19 03 Defect list error in grown list

1A 00 Parameter list length error

1B 00 Synchronous data transfer error

1C 00 Defect list not found

1C 01 Primary defect list not found

1C 02 Grown defect list not found

1D 00 Miscompare during verify operation

20 00 Invalid command operation code

21 00 Logical block address out of range

24 00 Invalid field in CDB

25 00 LUN not supported

26 00 Invalid field in parameter list

26 01 Parameter not supported

26 02 Parameter value invalid

26 03 Invalid field parameter; threshold parameter

26 98 Invalid field parameter; checksum

26 99 Invalid field parameter; firmware tag

27 00 Write-protected

28 00 Not ready-to-ready transition; medium may have changed

29 00 Power-on, Reset, or bus device reset occurred

29 01 Power-on Reset occurred

2A 00 Parameters changed

2A 01 Mode parameters changed

2A 02 Log parameters changed

2F 00 Tagged commands cleared by another initiator