- Hewlett-Packard Tool Storage User Manual

Installation & Configuration
Installing Additional Modules
15
Installation
Installing a DDS Tape Module
To install DDS tape module:
1. Shut down the host and power-off the storage system.
2. Read and remove the module “Attention” label (see Figure 7).
3. Pull out the module lever (See Figure 9).
CAUTION! Pull the module lever all the way out, or the module will jam in the slot.
4. Install the DDS tape module in a single-ended (SE) slot.
5. Push in the module lever until it clicks to lock the module in place.
Figure 9. Installing a DDS Tape Module