Technical data
E1
2-2 97060A Environmental Installation,PM
Installation Procedure
1.
Ensure that the
HP
27II2A
GPIO interface card has
its
switches set as shown:
W1,
W2,
W3
Jumper in 5V Position
+5
r:i:!le + 12
Jumper in 12V Position
+5
e£I:!J+12
W1
GPIO Interface Card Switch Settings
2.
Install the HP
27II2A
GPIO card
in
an interface card slot
in
the computer or HP 97098A
I/O
Expander. and connect the GPIO interface cable to the card.
3.
Connect the other
end
of the GPIO cable to the 97060A connector labeled "J9/GPIO
HOST".
4.
Interconnect the 97060A
and
the monitor with the three 1.8-metre BNC cables. red to red.
green to green.
and
blue to blue.
5.
Set the monitor so that the video signal
is
terminated
with
75 ohms.
6.
If you are installing the HP
911IA
Data Tablet. connect an HP-IB cable from the
9I11A
to
the
97060A input jack labeled
"JI0'GPIB
TABLET'. Ensure that the
9IIIA
device address
is
set to 6
and
that no other interface cable
is
connected to the
9IIIA.