Specifications

Model 900 Technical
Page O4
IMPORTANT
Prior to any mounting, the operator must check that
the carrier characteristics correspond to the
required specifications, mainly:
- Weight, flow and setting of relief valve(s) mounted
on breaker line (refer to technical specifications
sheet).
Prior to any mounting, a flow and pressure test of
the breaker circuit is imperative.
The operator will make sure that the hydraulic
installation is acceptable as given and it cannot
allow the inverse feeding of the breaker by the
"return line".
Note: The breaker pressure line (HP line) is located
on the right side of the breaker.
Some carriers might have inverted piping (pressure
line on the left side of the carrier boom).
Clearly identify HP pressure and return lines on
carrier boom.
If necessary, cross over the breaker hoses to allow
proper connection.
IMPORTANT
Avant tout montage, l'opérateur dolt s'assurer que
le porteur devant être équipé, correspond aux spé-
cifications données principalement:
- Poids, débit et pression de tarage du(des)
clapet(s) de décharge situé(s) sur la ligne brise
roche (Voir feuille spécifications techniques).
Un contrôle du débit et de la pression du circuit
brise roche est Indispensable.
Il doit vérifier que l'installation hydraulique est con-
forme au schéma de principe fourni et qu'elle ne
permet pas I'alimentation inverse du marteau par le
circuit "retour".
Note: La ligne d'alimentation (HP) est située coté
droit du brise roche.
Certains porteurs peuvent avoir des circuits inver-
sés ( HP à gauche du bras).
Identifier clairement les circuits HP et BP du bras.
Si nécessaire, croiser les flexibles de raccordement
du brise roche pour permettre un branchement
correct.